- Composition / Information on Ingredients
|
Identification of the product
|
:
|
Hot Melt Adhesive
|
|
Ingredients
|
|
CAS NO.
|
|
Ethylene-Vinyl Acetate
|
30 – 90%
|
24937 – 78 - 8
|
|
Hydrogenated hydrocarbon resin
|
10 – 70%
|
69430 – 35 - 9
|
- Hazardous Identification
Physical and Chemical Hazards / Fire and Explosive Hazards
|
Low Hazard
|
:
|
Material can form flammable mixtures or can burn only upon heating to the temperatures at or above the flash point.
|
|
Decomposition
|
:
|
Flammable / toxic gases will form upon decomposition.
|
- First – Aid Measures
|
Inhalation
|
:
|
If symptomatic, move to fresh air. Get medical attention if symptoms persist.
|
|
Skin Contact
|
:
|
Wash with soap and water. If burned by contact with molten material, cool as quickly as possible. Do not peel material from skin.
|
|
Eye Contact
|
:
|
Immediately flush eyes with large amounts of water for at least 15 minutes. Get prompt medical attention.
|
|
Ingestion
|
:
|
First aid is normally not required.
|
- Fire Fighting Measures
|
Extinguishing
|
:
|
Water spray, dry chemicals
|
|
Special Fire Precaution
|
:
|
Wear self-contained breathing apparatus and protective clothing
|
|
Hazardous Combustion Products
|
:
|
Under oxygen deficient conditions Carbon Monoxide (CO) and irritating smoke may be produced.
|
- Accidental Release Measures
Sweep or scoop up and remove
- Handling and Storage
|
Storage Temperature (°C)
|
:
|
Ambient
|
|
Transport Temperature (°C)
|
:
|
Ambient
|
|
Stirage / Transport Pressure (Kpa)
|
:
|
Atmospheric
|
|
Personal Precautionary Measures
|
:
|
No special precautionary measure should be needed under anticipated conditions of use.
|
|
Prevention of Fire and Explosion
|
:
|
Keep from contact with oxidizing materials.
|
- Exposure Controls / Personal Protection
Engineering Control Measures :
Local exhaust ventilation of process equipment may be needed to control aerosol exposures to below the recommended threshold exposure limit.
Personal Protection :
- Where eye contact may occur, wear safety glasses with side shield.
- Where skin contact may occur with hot materials, wear thermal resistant gloves, arm protection and a face shield.
- Where overexposure by inhalation may occur, and engineering, work practice or other means of exposure reduction are not adequate, approve a respirators may be necessary.
- Physical and Chemical Properties
|
Physical State
|
:
|
Solid
|
|
Form / Colour
|
:
|
Water white or opaque in colors, stick or granule in forms.
|
|
Odor
|
:
|
Odorless or resin odor
|
|
PH
|
:
|
Not applicable
|
|
Boiling Point
|
:
|
Not applicable
|
|
Specific Gravity
|
:
|
0.92 – 0.98 g/cm3
|
|
Solubility in Water
|
:
|
Negligible
|
|
Viscosity
|
:
|
8,000 – 14,000 CPS / 180°C
|
|
Flash Point
|
:
|
Over 200°C
|
|
Explosive Limit
|
:
|
Not available
|
